Jump to content

Talk:Ion implantation

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

Silicon on Insulator

[edit]

Contextualized SmartCut in terms of generic wafer bonding. Technique is novel and widely used and deserves inclusion but previous text read like a sales brochure for SOITEC. Irene Ringworm 19:11, 29 December 2006 (UTC)[reply]

Is it right to say that a SOI MosFet is a 250 nm channel of crystaline Si between two amorphous SiO2 layers? The upper interface is sharp, while the lower is gradual. Above the upper SiO2 is the front gate and the substrate serves as the back gate Arnero 07:48, 1 April 2007 (UTC)[reply]

Safety?

[edit]

The "safety" section seems worse than useless. Life is dangerous, and coming into accidental contact with an ion implantation device ranks low on the List of Things to Worry About. It's also very poorly written and confusing.

The writing could be fixed, but it would be best to just dump it. 12.103.251.203 02:32, 13 February 2007 (UTC)[reply]

One can say the same thing about any other specialized equipment that the general public is not exposed to. However, the article clearly specifically mentions that this is for workers on the equipment. As a technical instructor for a company that manufacturers ion implanters, I can assure you the hazards mentioned are certainly valid. I would add that fluorine from some of the dopant sources (e.g. BF3, SiF4) will react with moisture in the vacuum exhaust lines to form hydrofluoric acid, which can cause severe chemical burns, and can react with blood calcium which can cause cardiac arrest. Sean Degnan 98.229.8.244 (talk) 15:05, 10 November 2012 (UTC)[reply]

Can someone remind me why plasma wakefield acceleration, something that has absolutely zero to do with ion implant, is part of this? 173.76.18.244 (talk) 21:42, 20 March 2022 (UTC)[reply]

Manufacturers of Ion Implantation Equipment

[edit]

Since when has wikipedia been an advertising vehicle or white pages? 150.203.35.113 (talk) 06:58, 1 October 2010 (UTC)[reply]